[DAQ-CARD] ACL-7225
조회 : 1,112 | 12-10-24 12:53
관리자

  • 16 relay actuator outputs
  • 16 opto-isolated AC or DC polarity-free digital inputs
  • LEDs indicate the energized relays
  • Input jumpers select AC Filter/ Non-AC Filter modes
  • 1,000 VDC isolation
  • On-board relay driving circuits
  • On-board digital input signal conditioning circuits
  • 37-pin D-type female connector
     
     
     
    제품사양
     
     
    Relay Outputs
    • Relay type: Single-Pole-Double-Throw (SPDT)
    • Output channels: 16
      • Form C: CH# 0~4 and 8~12
      • Form A: CH# 5~7 and 13~15
    • Form C contacts: with Normal Open and Normal Closed
    • Form A contacts: Normal Open only
    • LED indicates each relay's ON/OFF status for monitoring.
    • Contact type: 120VAC @ 0.5A or 24VDC @ 1A
    • Contact resistance: Bifurcated
    • Relay ON/OFF time: 5 msec. typical
    • Coil voltage: +12V @ 33mA for each rela
     
    • Isolated Inputs
      The 16 photo-isolated DI channels are used for sensing digital inputs and provide 1,000VDC isolation. Each can be configured with AC Filter or Non-AC Filter by jumper settings.
    • Number of input channels: 16
    • Photo isolators: PC-814
    • Input signal type: AC or DC
      • AC: don't care polarity
      • DC: with polarity
    • Input voltage: 5~24VDC or AC 50~1,000Hz
    • Input filters: RC low pass filter
    • Input impedance: 1.2k Ohm
    • Isolation voltage: 1,000VDC channel-to-channel and channel-to-ground
    • Response time:
      • 20 sec without AC Filter
      • 2.2ms with AC Filter
     
    General Specifications
    • Operating temperature: 0줩 ~ 55줩C
    • Storage temperature: -20줩 ~ 80줩C
    • Humidity: 5~90%, non-condensing
    • Power consumption:
      • +5VDC: 310mA typical
      • +12VDC: 550 mA maximum, all relays are energized
    • Dimensions: 177 mm x 122 mm

  •